Electrical Safety; Special Safety Instructions For That Machine; Hazard Warnings; Residual Risks - HOLZMANN-MASCHINEN HOB 260ABS Betriebsanleitung

 Wear suitable work clothing (eye protection, ear protection, dust mask, safety shoes) and
close-fitting protective clothing - never loose clothing, ties, jewellery, etc. - danger of
being drawn in!
 Work with gloves is not permitted!
 Hide long hair under hair protection.
 Do not remove splinters and chips by hand, use a sliding stick instead!
 Do not remove any sections or other parts of the workpiece from the cutting area while
the machine is running!
 Use a sliding stick!
 Only operate the machine with an effective extraction system.
 Always work with care and the necessary caution and never use excessive force.
 Do not overload the machine!
 Do not work on the machine if you are tired, not concentrated or under the influence of
medication, alcohol or drugs!
 Do not use the machine in areas where vapours from paints, solvents or flammable liquids
represent a potential danger (danger of fire or explosion!).
 Do not smoke in the immediate vicinity of the machine (fire hazard)!
 Make sure that the main switch is in the "O" position before connecting the machine to the
power source.
 Ensure that the machine is earthed.
 Only use suitable extension cords.
 Always shut down the machine before carrying out any conversion, adjustment,
measuring, cleaning, maintenance or repair work and always disconnect it from the power
supply for maintenance or repair work. Before starting work on the machine, wait until all
tools or machine parts have come to a complete standstill and secure the machine against
unintentional restarting.

14.5 Electrical Safety

 Make sure that the machine is earthed.
 Only use suitable extension cords.
 A damaged or tangled cable increases the risk of electric shock. Handle the cable with
care. Never use the cable to carry, pull or disconnect the machine. Keep the cable away
from heat, oil, sharp edges or moving parts.
 Proper plugs and sockets reduce the risk of electric shock.
 Water that enters the machine increases the risk of electric shock. Do not expose the
machine to rain or moisture.
 The machine may only be used in humid environments if the supply is protected by a
residual current circuit breaker.
 Do not use the machine if it cannot be turned on and off with the ON/OFF switch.

14.6 Special Safety Instructions for that machine

 Work with gloves on rotating parts is not permitted!
 Wood dust is generated when the machine is in operation. Therefore, connect the machine
to a suitable extraction system for dust and chips during installation!
 Never remove chips or other parts of the workpiece from the cutting area while the
machine is running.
 When using milling tools with a diameter of ≥ 16 mm and circular saw blades, these must
comply with EN 847-1:2013 and EN 847-2:2013; tool carriers must comply with EN 847-
3:2013;
 Excessive noise can cause hearing damage and temporary or permanent hearing loss.
Wear hearing protection certified to health and safety regulations to limit noise exposure.
 Only use blades that are suitable for that machine.

14.7 Hazard Warnings

Despite the intended use of the machine, certain residual risks remain.

14.7.1 Residual risks:

 Risk of injury caused by tools, especially when changing tools
 Risk of injury caused by workpieces/workpiece parts that can be thrown away
 Risk of injury caused by kickback of the workpiece.
Due to the design and construction of the machine, hazardous situations may occur when
handling the machines, which are identified as follows in these operating instructions:
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
SAFETY
38
HOB 260ABS