Built-In Memory; Synchronizing Additional Wireless Sensor(S) (Optional) - Bresser 7003300 Bedienungsanleitung

Note:
- The backup battery can backup: Time & Date, Max/Min & Past 24 hours weather records, Alert setting values,
offset value of weather data and sensor(s) channel history.
- The built-in memory can backup: Router setting and Weather server setting .
POWER UP THE CONSOLE
1 . Plug the power adapter to power up the console .
2 . Once the console power up, all the segments of the LCD will be shown .
3 . The console will automatically start AP mode .
NOTE:
If no display appears when power up the console . You can press [ RESET ] key by using a pointed object .
If this process still not work, you can remove the backup battery and unplug the adaptor then re-power up
the console again .
SET LCD DISPLAY VIEWING ANGLE
Press [ ] or [ ] key in normal mode to adjust LCD viewing angle to fit table stand or wall
mount situation .

BUILT-IN MEMORY

The console has built-in FLASH memory that holds the vital settings . These include:
- Time Zone, DST status, Time SYNC status, WI-FI and Weather server setting, Latitude / Longitude,
Hemisphere setting, Calibration values, and Sensor ID of paired sensor(s)
RESET AND FACTORY HARD RESET
To reset the console and start again, press the [ RESET ] key once or remove the backup battery and then
unplug the adapter . To resume factory settings and remove all data, press and hold the [ RESET ] key for 6
seconds .
RESYNCHRONIZE SENSORS
Press the [ SENSOR / WI-FI ] key once for the console to enter sensor Synchronization mode, and the
console will re-register all the sensors that have already been registered to the it before . i .e . the console will
not lose the connection of the sensors that you'd paired up before .
CHANGING BATTERIES AND MANUAL PAIRING OF SENSOR
Whenever you changed the batteries of the wireless thermo-hygro or 7-in-1 weather sensor,
re-synchronization must be done manually .
1 . Change all the batteries to new ones in the sensor .
2 . Press [ SENSOR / WI-FI ] key on the console to enter sensor synchronization mode .
3 . Press [ RESET ] key on the wireless thermo-hygro or 7-in-1 weather sensor .

SYNCHRONIZING ADDITIONAL WIRELESS SENSOR(S) (OPTIONAL)

The console can support up to 7 additional wireless sensors .
1 . Press the [ SENSOR / WI-FI ] key once on the console to enter synchronization mode .
2 . Press the [ RESET ] key on the new sensor, and wait for a few minutes for the new sensor
to paired to the console .
NOTE:
- Channel number of the
- This console can support different type of additional wireless sensor, e.g. soil moisture and pool sensor. If
you would like to pair up additional sensors, please check with your retailer for more detail .
wireless
thermo-hygro sensor must not be duplicated among the sensors .
39