Assembly Of The Filter - BWT RTM CT Montage- Und Bedienungsanleitung

2.

ASSEMBLY OF THE FILTER

1
2
3
4
1
CONSTRUCTION & RÉNOVATION
Pass the collector pipe into the filter and screw on the laterals, be careful not to
over tighten.
Check that the drain valve is closed.
Fill the pump with water until the water level is 5 cm above the laterals.
Fit the centring tool to the collector pipe.
Pour the sand (granulometry 0.6/1.25) in carefully to avoid damaging the laterals.
Loosen the ring.
Remove the centring tool.
Fit the o-ring Ø 230 X 8 (Ref 1) into the groove in the lid.
Mount the lid/valve assembly on the filter.
Tighten the lid nut moderately by hand
2021/01 - Indice de révision : F - Code : 26730
17/36