Technical Data; Noise Emission Values - EINHELL TKS 1700 Bedienungsanleitung

Anleitung_TKS_1700_4340668:_
trade or industrial businesses or for equivalent
purposes.
Only saw blades designed for the machine
should be used (HM or CV saw blades). Use of
HSS saw blades and cutting disks is prohibited.
To use the machine properly you must also
observe the safety instructions, the assembly
instructions and the operating instructions to be
found in this manual.
All persons who use and service the equipment
have to be acquainted with this manual and
must be informed about the machine's potential
hazards. It is also imperative to observe the
accident prevention regulations in force in your
area. The same applies for the general rules of
health and safety at work.
The manufacturer will not be liable for any
changes made to the machine nor for any
damage resulting from such changes. Even
when the equipment is used as prescribed it is
still impossible to eliminate certain residual risk
factors. The following hazards may arise in
connection with the machine's construction and
design:
Contact with the saw blade in places where
it is not covered.
Reaching into the moving saw blade (cuts)
Recoil of workpieces and parts of
workpieces from the machine.
Breakage of the saw blade.
Expulsion of defective hard metal parts from
the saw blade.
Damage to hearing if ear-muffs are not used
as necessary.
Harmful emissions of wood dust when used
in closed rooms.
The product complies with the requirements
of the EN 61000-3-11 and is subject to
special connection conditions. This means
use at freely chosen normal connection
points is prohibited.
The appliance can lead to temporary
fluctuations in voltage if the mains supply is
unreliable.
As an operator you must make sure (if
necessary consult your power supply
company) that your connection point where
you wish to connect this product has a
13.05.2009 14:04 Uhr Seite 19
resilient steady mains current of at least 100
A per phase.

6. Technical data

AC motor
Power rating P
Idle speed n
Carbide saw blade
Number of teeth
Bench size
Table width extension, left/right 620 x 250 mm
Table length extension, rear
Cutting height max.
Height adjustment
Tilting saw blade
Dust extraction connector
Dimensions of the tool including
removable parts:
Operating mode S6: Continuous operation
with idling (cycle time 10 minutes.)
To prevent unnecessary heating of the motor,
the bench circular saw may only be used in the
following ways:
After operation for 4 minutes (S 6 = 40%) with
normal permitted workload, a break of 6
minutes must follow, in order to let the circular
saw idle and cool.

Noise emission values

sound pressure level L
sound power level L
The quoted values are emission values and not
necessarily reliable workplace values. Although
there is a correlation between emission and
immission levels it is impossible to draw any
certain conclusions as to the need for additional
precautions. Factors with a potential influence
on the actual immission level at the workplace
include the duration of impact, the type of room,
230 V ~ 50Hz
S6 40% 1700 W
4,800 rpm
0
Ø 250 x Ø 30 x 2.8 mm
626 x 445 mm
435 x 320 mm
73 mm / 90°
63 mm / 45°
infinite 0 - 73 mm
infinite 0° - 45°
Ø 36 mm
33.5 kg
Idle speed
96,2 dB(A)
pA
109,2dB(A)
WA
GB
24
19