Mounting and Operating Instructions
Brillant 1503 ... 1704 LED CG-S
3. Safety Notes
p The luminaire shall only be used for its intended purpose and in an indamaged and perfect condition!
p Only genuine CEAG spare parts may be used for replacement and repair!
p When working on the emergency luminaire first the system must be blocked, battery operation must
be interrupted and mains must be cut off. Enclosed indication label on the emergency luminaire:
p Prior to its initial operation, the luminaire will have to be checked in accordance with the instructions
as per section 'Installation'!
p Carry out the marking of the emergency luminaire:
Assign the circuit, the luminaire no. and ID no. and enter them.
p The manual log book shall be performed in compliance with the national regulations. It is not
applicable by automatical log book!
p Any foreign matter shall be removed from the luminaire prior to its initial operation!
p Observe the national safety rules and regulations for prevention of accidents as well as the safety
instructions included in these operating instructions marked with
4. Conformity to standards
Conforms to: EN 60 598-1, EN 60 598-2-22 and DIN EN 1838.
Developed, manufactured and tested in accordance with DIN EN ISO 9001.
5. Technical Data
Input voltage:
Viewing distance
1503 ... 1703:
1504 ... 1704:
Current consumption battery operation: 1503 ... 1703: 12 mA
Power consumption mains operation
(apparent power / effective power):
Enclosure material:
Colour of enclosure:
Luminous flux phiE/phiNenn at the end
of rated operating time
Supply terminals:
Insulation class:
Degree of protection acc. to EN 60529: IP 20
Lamp:
Admissible amb. temperature
Weight:
10
220-240 V AC, 50/60 Hz, 176 V - 275 V DC
20 m
30 m
1503 ... 1703: 5.5 VA/2.9 W
Aluminium, sheet steel
White
100%
plug-in terminal 2.5 mm²
I
LED-strip with 3 chip LEDs
-10°C...+40°C
1503: 2.3 kg
1603: 2.2 kg
1703: 1.8 kg
!
1504 ... 1704: 17 mA
1504 ... 1704: 7.1 VA/4.1 W
1504: 2.7 kg
1604: 2.5 kg
1704: 2.2 kg