Description Of The Unit; Description • Technical Data And Operating Limits - AERMEC Omnia UL N-Serie Bedienungs- Und Installationsanleitung

DESCRIPTION OF THE UNIT

AIM OF THE UNIT
The fan coil is a room air treatment terminal unit for both winter and summer operation.
Omnia UL_N version
A fan coil with cabinet, for universal installation and fitted with a multifunction electronic thermostat. It can be installed as an
autonomous unit or within a network: it can, in fact, manage a network of a further 5 fan coils*.
* The fan coils within a network must be pre-arranged models, or equipped with the special accessories.
AVAILABLE SIZES
The Omnia UL_N fan coils are available in 4 sizes.
TECHNICAL DATA AND OPERATING LIMITS
Omnia UL
Heating output (water input 70°C)
Cooling output (water input 7°C)
Input power
Input current
Maximum water inlet temperature
Maximum operating pressure
Room temperature limits Ta
Relative humidity limits in the room R.H.
Protection rating
Power supply
Performance values refer to the following conditions:
- at the maximum motor speed;
Water temperature
In order to prevent air stratification in the
room, and therefore to achieve improved
mixing, it is advisable not to supply the fan
coil with water at a temperature over 65°C.
Minimum average water temperature
If the fan coil is working in continuous
cooling mode in an environment
where the relative humidity is high,
condensate might form on the air
delivery and on the outside of the
device. This condensate might be
Minimum average water temperature [°C]
Temperature with wet bulb
of the air in the room
30
IULNIJ 1711 - 4528500_01
11 N 16 N
[W] 2010 2910
[W] 840 1200
[W] 18
[A] 0.09
[°C] 80
[bar] 8
IP
[V ~ Hz]
- the total input power is determined by adding the input power
for the unit and the input power for the accessories connected
and declared in the corresponding manuals.
The use of water at high temperatures
could cause squeaking due to the different
thermal expansions of the elements
(plastic and metal), this does not however
deposited on any objects underneath
and on the floor.
To avoid condensate on the external
structure of the device while the fan is
functioning, the average temperature of
the water must not be lower than the
21
15
17
19
21
23
26 N
4620
2030
32 35
0.15 0.18
80 80
8 8
0°C < Ta < 40°C
R.H. < 85%
20
230V ( ±10%) ~ 50Hz
cause damage to the unit if the maximum
operating temperature is not exceeded.
limits shown in the table below, that
depend on the thermo-hygrometric con-
ditions of the air in the room.
These limits refer to unit operating with
fan at minimum speed.
Temperature of the air in the room with dry bulb
23 25
3 3 3
3 3 3
3 3 3
6 5 4
- 8 7
36 N
5940
2830
42
0.22
80
8
27 29 31
3 3 3
3 3 3
3 3 3
3 3 3
6 5 5