Safety Information For Circular Saw Blades - Parkside PHKS 1350 C2 Originalbetriebsanleitung

Lower guard function
a) Check lower guard for proper closing before
each use. Do not operate the saw if lower
guard does not move freely and close
instantly. Never clamp or tie the lower guard
into the open position. If saw is accidentally
dropped, lower guard may be bent . Raise the
lower guard with the retracting handle and
make sure it moves freely and does not touch
the blade or any other part, in all angles and
depths of cut .
b) Check the operation of the lower guard
spring. If the guard and the spring are not
operating properly, they must be serviced
before use. Lower guard may operate slug-
gishly due to damaged parts, gummy deposits,
or a build-up of debris .
c) Lower guard may be retracted manually only
for special cuts such as "plunge cuts" and
"compound cuts". Raise lower guard by
retracting handle and as soon as blade enters
the material, the lower guard must be released .
For all other sawing, the lower guard should
operate automatically .
d) Always observe that the lower guard is
covering the blade before placing saw down
on bench or floor. An unprotected, coasting
blade will cause the saw to walk backwards,
cutting whatever is in its path . Be aware of the
time it takes for the blade to stop after switch is
released .
PHKS 1350 C2
Supplementary notes
■ Do not use any grinding discs .
■ Use only saw blade with diameters corre-
sponding to the label on the saw .
■ When sawing wood or other materials which
may create dusts that are hazardous to health,
always connect a suitable, certified vacuum
extractor device .
■ Wear a dust mask when sawing wood .
■ Use only the recommended saw blades .
■ Always wear ear protectors .
■ Do not allow the teeth of the saw blade to
overheat .
■ When sawing plastic, avoid melting the plastic .
■ Always use the correct saw blade for the
material being worked .
■ Use only saw blades with a speed marking
which corresponds to or is higher than the speed
specified for the power tool .
■ Saw blades intended for use on wood or similar
materials must comply with EN 847-1 .
Safety information for circular
saw blades
Wear protective gloves!
Wear respiratory protection!
Wear protective glasses!
Wear hearing protection!
GB │ IE │ NI │ CY │ 7 ■