Genuine Accessories/Auxiliary Equipment; Information On Saw Blades; Before Initial Use; Charging The Battery (See Fig. A) - Parkside PSTDA 18-Li B2 Betriebsanleitung

■ When you use the splinter guard
GB
sliding shoe
IE
■ After completing your work, switch the power
tool off and do not pull the saw blade
of the insert until the tool has stopped entirely.
This prevents kickbacks, and allows you to put
the tool down safely.
■ Only use undamaged saw blades that are
in perfect working order. Bent and blunt saw
blades can break or may cause a kickback.
■ Secure the workpiece. Use clamps/a vice to
hold the workpiece firmly. This is safer than
simply holding it in your hand.
■ Never work on moistened materials or damp
surfaces.
■ Dust may be hazardous! When working for
extended periods on wood and, in particular,
materials that produce dusts that are hazardous
to health, connect the appliance to an appropri-
ate dust extraction device.
■ Wear a dust mask.
■ Ensure there is sufficient ventilation.
Genuine accessories/auxiliary equip-
ment
■
Only use the accessories and auxiliary
equipment that are specified in the operat-
ing instructions or that are compatible with
the appliance.

Information on saw blades

Parkside basic equipment includes saw blades
principally for use with wood and metal.
▯ 2 saw blades for general wood cutting
▯ 1 saw blade for light metals up to 3 mm
NOTE
► You can use any saw blade provided it is fitted
with a suitable mounting (single-lug shank).
Saw blade type
suitable
6
, take off the
first.
unsuitable

Before initial use

Charging the battery (see Fig. A)

CAUTION!
out
► Always unplug the appliance before you
remove the battery pack from or connect the
battery pack to the charger.
NOTE
► Three appliances - three compatible batteries.
Interchangeable!
(see chapter ordering a replacement battery)
■ Never charge the battery pack when the ambi-
ent temperature is below 10°C or above 40°C.
♦ Connect the battery pack
tery charger
♦ Push the mains plug into the mains power
socket. The control LED
♦ The green control LED
charging process is complete and the battery
pack is ready.
♦ Push the battery pack
■ Never recharge a battery pack again im-
mediately after rapid charging. This could
overcharge the battery pack, thus reducing the
lifespan of the battery and charger.
■ Switch off the charger for at least 15 minutes
between successive charging sessions.
Also disconnect the power plug from the mains
power socket.
Attaching/disconnecting the
battery pack to/from the appliance
Inserting the battery pack:
♦ Allow the battery pack
the appliance.
Removing the battery pack:
♦ Press the release button
battery pack.
to the rapid bat-
(see Fig. A).
will light up red.
indicates that the
back into the appliance.
to click into place in
and remove the
PSTDA 18-Li B2