Establishing Connection Manually With A Wireless Router (St 411 Only) - Rohde ST 410 Bedienungsanleitung

Step Description of the process
After a few seconds, "PAIR" disappears
from the main display and the control unit
7
shows normal information in the main
display.
The ST 411 control system is now
8 permanently connected to the wireless
network (Wi-Fi).
Connecting the computer or smartphone to
9
the Wi-Fi.
8.2.4.

Establishing connection manually with a wireless router (ST 411 only)

Process to manually connect an ST 411 control unit to a wireless network using a computer or smartphone:
Step Description of the process
1 Switch the control unit off.
f
Press the key and switch on the control
2
unit.
Hold down the
3
the main display.
f
4
Release the
Using a computer or smartphone, manually
5 search for a wireless network (Wi-Fi) or
access point.
A wireless network named "Controller"
6
should appear.
Connect the device to the wireless network
7
called "Controller".
Open the web browser on your computer or
8
smartphone.
Enter "192.168.100.1" in the address bar
9
and go to this address.
A list of available wireless routers is now
10
displayed in the "Wi-Fi Connection" tab.
The appropriate wireless router should now
11
appear as available in this list.
f
key until "AP" appears in
key.
Remark
If this procedure was unsuccessful, repeat the steps starting
with step 1 or try the connecting as described in Section 8.2.4.
Available networks can be searched for on the computer or
smartphone in the system settings.
Remark
f
Hold down the key while switching on.
1)
"AP" stands for Access Point.
2)
The control unit creates its own wireless network.
3)
The wireless network via the access point is limited in time and
is closed each time the controller is switched off.
⇒ The computer and smartphone need to activate Wi-Fi and
scan for new devices.
⇒ Available networks can be searched for on the computer or
smartphone in the system settings.
⇒ The control unit and the computer or smartphone must be in
the immediate vicinity.
Ignore the following warnings from your computer or
smartphone:
­ The internet is not available.
­ This wireless network has no internet access. Connect
anyway.
­ Unsecured network
­ The process of connecting to the Wi-Fi may take a while.
­ Similar warnings may vary depending on the device used.
Executable with all common web browsers.
This so-called "web interface", which is now displayed in the
web browser, consists of 2 tabs, but only the displayed "Wi-Fi
Connection" tab is important for establishing the connection.
The web interface scans for available wireless networks in the
area and displays them in a list.
71 / 280