Disposal; Trouble Shooting - Zipper Maschinen ZI-KGS305UK Betriebsanleitung

14.6 Disposal

Do not dispose the machine in residual waste. Contact your local authorities for
information regarding the available disposal options. When you buy at your local dealer for
a replacement unit, the latter is obliged to exchange your old.
15

TROUBLE SHOOTING

Danger due to electrical voltage! Manipulating the machine with the power supply
up can lead to serious injuries or death. Always disconnect the machine from the
power supply before carrying out any troubleshooting work!
Many possible sources of error can be excluded in advance if the machine is properly connected to
the mains.
If you are unable to carry out necessary repairs properly and/or do not have the required training,
always consult a specialist to correct/solve the problem!.
Trouble
Engine doesn't run
(or not correctly)
Saw blade gets stucked
Material kickback
Wrong cutting angle
Wrong mitre angle
Saw blade touches the
machine bed
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-KGS305UK
W A R N I N G
Possible cause
 Switch defective
 Power supply is off
 Carbon brushes defective
 Motor defective
 Blunt saw blade
 Too hard materal or too
much pressure
 Blunt saw blade
 Wrong running direction
of the saw blade
 Wrong adjusted fence or
saw aggregate
 Adjusting the cutting
depth wrong
TROUBLE SHOOTING
Solution
 Repair switch
 Repair power supply
 Chang carbon brushes
 Repair or change motor
 Sharpening or changing
 Conform the cutting
speed on work piece
hardness and engine
power
 Sharpening or changing
 Control
 Control
 Control
31