Herunterladen Inhalt Inhalt Diese Seite drucken

Remaining Risk Factors - Zipper Maschinen ZI-KGS305UK Betriebsanleitung

Kapp- & gehrungssäge inkl. untergestell
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Do not stop the saw blade by touching it on the side. This will ruin the drive mechanism.
Do not manipulate or remove the saw blade protecting cover!
Do not fix small workpieces by hand, instead only use the downholder.
No material feed, no material removal, no adjustments or other activities when saw blade is running.
Do not position your hands near the saw blade or in a way that they could slip into the cutting line.
Long workpieces have to be supported by the double bar guide.
Take especially care when cutting round workpieces!
Check the workpiece for nails, clamps and other material!
Just cut one workpiece at once. Do not stack or attempt to cut several work-pieces in one cutting
operation!
Do not cut firewood
Wear gloves when handling the saw blades and rough materials. It is recommended that saw blades,
whenever practicable be carried in a container.
Make sure that the speed indicated on the saw blade is at least as high as that on the saw speed
specified.
Be sure to use only those spacers and screw rings, which are suitable for the purpose specified by
the manufacturer.
No reload, remove or adjust workpieces, or material remains with the machine running!
Do not place hands in near circular saw blade or in a position where they could slip direction circular
saw blade!
The use of other application tools and other accessories can mean a risk of personal injury.
Let your power tool repaired by a qualified electrician
The machine does not require extensive maintenance. If malfunctions and defects occur, let it be
serviced by trained persons only.
Instructions for the use of the LASER:
Do not look directly into the laser beam with unprotected eyes.
Never point the laser beam at reflective surfaces or persons or animals. Even a low-power
laser beam can cause eye damage.
Never open the laser module. Unexpected exposure to the beam may occur.
Do not replace the laser with another type of laser.
Repairs to the laser may only be carried out by the laser manufacturer or an authorized
representative

11.4 Remaining risk factors

It is important to ensure that each machine has remaining risks.
In the execution of all work (even the simplest) greatest attention is
required. A safe working depends on you!
Even if the machine is used as required it is still impossible to eliminate certain residual risk factors
totally. The following hazards may arise in connection with the machine´s construction and design:
Despite of correct and proper use and maintenance there remain some residual risk factors:
 Risk of injury to the hands / fingers by the rotating tool during operation.
 Risk of injury due to sharp edges of the workpiece, especially in non-fixed with a suitable tool /
device workpiece.
 Risk of injury: hair and loose clothing, etc. can be captured and wound up! Safety regulations must
be observed with regard to clothing.
 Risk of injury due to contact with live electrical components.
 Risk of injury due to breakage or cracking of the abrasive
 Risk of injury due to dust emissions, treated with harmful agents workpieces
 Risk of injury to the eye by flying debris, even with safety goggles.
 Risk of injury to the hearing by prolonged labor without hearing protection.
These risk factors can be minimized through obeying all security and operation instructions, proper
machine maintenance, proficient and appropriate operation by persons with technical knowledge and
experience.
ZIPPER MASCHINEN GmbH
www.Zipper-Maschinen.at
ZI-KGS305UK
W A R N I N G
SAFETY
23

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis