Adjustments; Angle; Cutting Depth - Zipper Maschinen ZI-KGS305UK Betriebsanleitung

13.2 Adjustments

13.2.1 Angle

Press the saw unit into the
lowered position
and press the release knob to lock
the sawing arm in its transport
position.
Release the mitre angle lock.
Turn the table until the miter
angle indicator points to 0°.
Tighten the mitre angle lock.
Release the vertical angle lock and set the saw unit to a vertical
angle of 0° (in other words the saw blade is at an angle of 90° to the
table. Tighten the vertical angle lock.
The edge of the angle bracket should run parallel to the saw blade.
If the saw blade is not parallel to the angle bracket, make the adjustment as
follows:
 Undo the lock screw on the sawing head vertical angle.
 Undo the vertical angle lock.
 Adjust the screw on the sawing head vertical angle with a screwdriver by
turning it clockwise and anti-clockwise so that the saw blade is on the 90°
angle bracket.
 Undo the screw which holds the pointer on the vertical angle scale and set
the pointer so that it points to 0°. Tighten the screw again.
 Tighten the vertical angle lock and the lock screw to secure the sawing head
vertical angle.

13.2.2 Cutting depth

Set the required cutting depth using the
setting screw.
Secure the stop screw using the lock nut
Slide the depht stop to the right.
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-KGS305UK
OPERATION
26