Sage the Oracle SES980BSS Kurzanleitung Seite 22

CARE & CLEANING
f. Repeat the above process on the left valve.
g. Empty the drip tray, use caution as the drip tray
may be hot.
h. Empty water tank, remove water filter.
i. Dissolve 1 sachet of Sage
1 litre of warm water. Pour solution into
the water tank.
NOTE
If water tank has not been removed, replaced
or is empty, "FILL TANK" will appear on the
LCD.
3 – Begin Descale
a. Press 1 Cup button and the LCD screen
will show countdown time (20 minutes).
During this time, the machine will fill boilers with
descale solution and heat to temperature. There
may be some water flow through the group head
during this time.
Allow the countdown timer to reach 0 as this allows
solution sufficient time to dissolve scale build up.
However you can proceed to the next step at any
time by pressing the 1 Cup button.
a. Place a cloth over the drip tray to stop steam
escaping.
b. Empty boilers by repeating steps
2c and 2d.
c. Empty drip tray and insert back to place.
d. Empty water tank then rinse and fill with clean
water to the MAX line. Lock water tank back
into position.
22
Descaler into
®
™
4 – Flush Boilers
a. Press 1 Cup button and the LCD screen
will show countdown time (20 minutes).
During this time, the machine will fill boilers
with fresh clean water and heat to temperature.
You can proceed to the next step at any time
by pressing the 1 Cup button.
b. Place a cloth over the drip tray to stop steam
escaping.
c. Empty boilers by repeating steps 2c and 2d.
d. Empty drip tray and insert back to place.
e. Empty water tank then rinse and fill with clean
water to the MAX line. Lock water tank back
into position.
5 – Repeat Step 4 Flush Boilers
We recommend flushing boilers again to ensure
any residual descale solution is released from
the boilers.
Press POWER button to escape the Descale
mode. The descale process is now complete
and ready to use.