Getting Started - Konig + Neurath TALO.S Bench Montageanleitung

Getting started

Make sure the bench has been set up correctly, that the plug to the
control panel is inserted firmly and that the cables from your office
equipment and the computer are in the appropriate trays. Connect the
desk to the mains. Initialise (manual reset) the bench as described on
page 49. You can now operate the bench as normal.
Ergonomics
You should always adjust the desk height so that your elbows form
an angle of at least 90° whether you are seated or standing.
Tip! Make sure your screen position does not cause glare.
48