Konig + Neurath TALO.S Bench Montageanleitung Seite 40

Wire management
Insert the umbilical with
clamp into the prepared
opening in the upper
cable tray (a) or lower
cable tray (b). Umbilical
(c) for connecting the up-
per and lower cable trays.
Caution:
The desks are delivered
prewired. Ensure that the
supply lines to the control
panel and the connection
cables for controlling the
lift columns do not hang
down, any excess length
should be accommodated
without loops in the cable
trays. Check this after
using the sliding top and
restore the correct state if
necessary.
Fitting the clip-on leg
covers
First, hang the inside pa-
nel (a) from the cross-
beam, then place the
outer panel (b) on top of it.
These are secured to the
frame by magnetic strips
in the panels.
You must follow the safety instructions! Improper use of
the system poses a risk of material damage and personal
injury!
(a)
(c)
(a)
(b)
37
(b)
The umbilical can be
shortened by removing
segments.