Snooze Function; Troubleshooting - Bresser WIFI ClearView 7in1 Bedienungsanleitung

9. Press the ALARM button once more to activate the frost warning alarm time. The symbols
are shown on the display.
10. To deactivate the alarm and frost warning, press the ALARM button until the alarm icons are no
longer displayed.

23 Snooze function

1. When the alarm sounds, press the SNZ/LIGHT button to activate the snooze function. Wake-up
call sounds again after 5 minutes.
2. When the alarm sounds, press any other key to stop the alarm until the set alarm time is reached
again.
3. If no key is pressed, the alarm is automatically switched off after 2 minutes.

24 Troubleshooting

Problem
The 7-in-1 wireless sensor
connection is interrupted or
has no connection
The wireless indoor sensor is
temporarily interrupted or dis-
connected
No WIFI connection
Data is not sent to wunder-
ground.com or weather-
cloud.net.
Wunderground Precip. Ac-
cum. Total graph offset 1
hour reset time (during sum-
mer time)
Rainfall is not correct
Temperature reading too
high during the day
18 / 40
Solution
1. 1. Make sure that the sensor is within the transmission range.
2. 3. If it still does not work, reset the sensor and resynchronize it with
the base station.
1. 1. Make sure that the sensor is within the transmission range.
2. 2. Make sure that the displayed channel matches the channel selec-
tion on the sensor
3. 3. If it still does not work, reset the sensor and resynchronize it with
the base station.
1. Check whether the WIFI symbol is shown on the display. It should al-
ways be displayed.
2. 2. Make sure that you connect to your WIFI router using the 2.4G
band and not the 5G band.
1. 1. Make sure that your Station ID and Station Key are correct.
2. Make sure that the date and time on the tablet are correct. If they are
incorrect, you may be reporting old data rather than real-time data.
3. Make sure that your time zone is set correctly. If it is set incorrectly,
you may report old data rather than real-time data.
1. 1. Make sure that the device's time zone is correctly set to Wunder-
ground.
2. 2. Make sure that the time zone and daylight saving time on your
base station are correct.
3. If you have located your station outside the U.S. time zone region in
Wunderground, daylight saving time is invalid. To solve this problem,
please disable the DST function in the base station.
1. 1. Please keep the rain collector clean
2. 2. Make sure that the tipping bucket inside can function smoothly.
1. 1,5. Place the sensor in an open area and at least 1.5 m above the
ground.
2. 2. Make sure that the sensor location is not too close to heat gener-
ating sources or obstacles such as buildings, pavement, walls, or air
conditioning units.
and