Maintenance; General Maintenance; Cartridge Change - BEKA HAMAX SYSTEM 2 Original - Betriebs- Und Montageanleitung

11. Maintenance

Disconnect the device from power supply before maintenance or repairs.
Only carry out maintenance and repair in complete device standstill and pressureless condition.
Check the surface temperature of the device to avoid the risk of burns by radiant heat. Wear heat-resistant gloves
and safety goggles! Clean soiled or contaminated surfaces before maintenance, wearing protective equipment if
necessary! Secure the device against recommissioning during maintenance and repair work!

11.1 General maintenance


Retighten all fittings 6 weeks after start up!

Check all components for leakages and damage at least every four weeks!
If leakages are not repaired, lubricant might escape under high pressure. Remove possible puddles of lubricant
immediately.

11.2 Cartridge change

Renew the cartridge when the cartridge follow-up piston (fig. 12, pos. 3) is on the bottom of the cartridge. The control of the follow-up
piston is easier because of the inspection window (fig. 12, pos. 4) in the pump housing or in the adapter.
Caution!
Always ensure cleanliness when changing the cartridge!

Unscrew the cartridge from the device and dispose of it professionally.

Insert the new cartridge as described in chapter 9.1 "Screw in cartridge"!

The lubricant change must be implemented according to the lubricant manufacturer's specifications. These intervals can be
shortened by environmental influences such as increased temperature or soiling!

Make sure that the quality of the lubricant corresponds to that of the prefilled lubricant in case of different lubricant suppliers! As a
precaution, the device should be completely and properly emptied and cleaned despite a good compatibility!
Fig. 12:
45 © BEKA 2019 All rights reserved!