Black+Decker KA230E Bedienungsanleitung Seite 27

OPERATING YOUR MULTI SANDER
Before plugging your multi-sander in, make sure it is
switched off.
VARIABLE SPEED CONTROL (KA210E/KA220E/KA230E)
Material
Hardwood (beech)
Softwood (pine)
Veneer wood
Synthetic materials
Acrylic sheet
Non-ferrous metals
Steel
Lacquer and paint removal
Polishing
Rust removal
USING YOUR MULTI SANDER AS A RANDOM ORBITAL
SANDER (KA200/KA220/KA220E/KA230E)
thus giving improved stock removal and reduced risk of
swirl marks.
FITTING THE ROUND BASE
Disconnect the plug from the electricity supply.
To switch your multi
sander on, press the
on/off switch on the
side marked "I".
To switch your multi
sander off, press the
on/off switch on the
side marked "O".
The variable speed
control gives the best
operating performance
for each material. As a
general rule, use low
speed for polishing and
for sanding acrylic/
synthetic materials,
and high speed for
wood and metal.
Variable speed setting
4-5
4-5
3-5
3-4
1-3
4-5
4-5
4-5
1-3
4-5
With the round base
fitted, you can use your
multi sander as a
random orbital sander.
This gives a circular/
orbital movement,
combined with a
rotational movement;
available as an accessory.
FITTING THE SANDPAPER (ROUND BASE)
Disconnect the plug from the electricity supply.
sander without a sandpaper disc.
USING YOUR MULTI SANDER IN THE ORBITAL MODE
(KA210/KA210E/KA220/KA220E/KA230E)
Detail sanding
Use your multisander with the point of the base
pointing forwards. This position permits you to sand
into difficult or confined areas.
Orbital sanding
Use your multi-sander with the point of the base to the
rear. This permits you to sand large areas with areas
and corners that have easy access.
FITTING THE POINTED BASE
Proceed as follows:
Disconnect the plug from the electricity supply.
washer in position on the base and fit the screw using
ENGLISH
Position the round base
on the spindle.
Position the washer on
the spindle and fit the
screw. Hold the base
and tighten the screw
with the allen key
provided. The base will
wear after some time.
Replacements are
Hold your multi sander
with the base upwards.
Press the sandpaper
disc onto the base,
making sure the base is
completely covered.
It is not necessary to
align the holes in the
paper and the base.
Never use your multi
Position the pointed
base on the spindle,
making sure the legs of
the base fit into their
housings. The base will
wear after some time.
Replacements are
available as an
accessory. Place the
27