Error Messages; Error Description - Microlife WatchBP Office ABI Bedienungsanleitung

Error messages

If an error occurs during measurement, the
measurement is interrupted and an error
message «Err» is displayed.
•
Please contact your local
Microlife service center if the
error persists.
•
If you think the results
are unusual, please read
through the information
in this instruction manual
carefully.
36
ROURINE
Error Description
«Err 1» Signal too
weak
«Err 2» Error signal
Potential cause and
remedy
The pulse signals
on the cuff are too
weak. Re-position the
cuff and repeat the
measurement.
During the
measurement,
error signals were
detected by the cuff,
caused for instance by
movement or muscle
tension. Repeat the
measurement, keeping
your arm still.