Scheppach csm 405 Original Anleitungen Seite 20

Problem
Motor doesn't start
Machine gets slower
during work.
Sanding belt comes off
the drive pulleys.
The wood gets burnt
during sanding.
Trouble shooting
Possible cause
a) ON/OFF switch damaged.
b) ON/OFF cable damaged.
c) ON/OFF relay damaged.
d) Fuse blown.
e) Motor burnt.
Too much pressure put on the workpiece.
Belt does not run straight.
a) Sanding disc or belt covered with
grease.
b) Excessive pressure on workpiece.
Remedy
a-d) Replace all damaged parts before you
use your machine again.
e) Contact your local service centre.
Every attempt to carry out a repair,
can be dangerous if it is not done by
skilled personnel.
Reduce the pressure on the workpiece.
Reset the track.
a) Replace disc or belt.
b) Reduce pressure on workpiece.
english 19