Connecting Remote Sensors; Temperature Display; Max/Min Weather Data; Technical Data - Bresser MyClimate Thermo-Hygro Bedienungsanleitung

1 New Moon
3 First quarter
5 Full Moon
7 Last quarter

13 Connecting remote sensors

The Weather Station can display the readings from up to 3 wireless sensors* of the same type. Each
radio sensor must be set to a separate channel. Proceed as follows to set the channel:
1. Remove the battery compartment cover of the wireless sensor.
2. Set the channel selection switch to the desired channel (CH1, CH2 or CH3).
3. Re-attach the battery compartment cover.
4. NOTICE! Each connected wireless sensor must be set to a different channel. If only one wire-
less sensor is connected, it should be set to CH1.
5. Press the CHANNEL button on the base station several times to display the measured values for
the individual channels. The selected channel is shown in the display.
6. Press CHANNEL button for about 3 seconds to reset the values and search for a wireless sensor
(RF signal).
*further wireless sensors are optionally available

14 Temperature display

In normal display mode, press the DOWN key to toggle between °C and °F.

15 MAX/MIN Weather data

The base station stores the maximum and minimum readings for indoor and outdoor temperature as
well as for the humidity:
1. Press the UP button repeatedly to display the stored values of the main unit and of the currently
set wireless sensor one after another.
2. Display sequence: Maximum values > Minimum values > Current values
3. When a stored value is displayed, press the UP button for about 3 seconds to delete the value.

16 Technical data

Base unit
Batteries
Maximum number of sensors
Temperature unit
Temperature measuring range
Humidity measuring range
Time format
Dimensions
Weight
2 Waxing Crescent
4 Waxing Gibbous
6 Waning Gibbous
8 Waning Crescent
2x AAA, 1.5 V
3
°C/°F
-0°C - 50°C (32°F to 122°F)
20% to 95% (RH)
12 or 24 hours
80 x 110 x 22 mm (W x H x D)
100 g (without batteries) 123 g (with batteries)
21 / 24