NOTE:
Changing from hemisphere setting will automatically switch the direction of the moon phase on the display.
MOON PHASE
In the Northern hemisphere, the moon
waxes (the part of the moon we see
that glows after the New Moon) from the
right. Hence the sun-lit area of the moon
moves from right to left in the Northern
Hemisphere, while in the Southern
Hemisphere, it moves from left to right.
Below is the table which illustrate how the
moon will appear on the console.
MAINTENANCE
BATTERY REPLACEMENT
When low battery indicator "
is low. Please replace the sensor batteries with new batteries accordingly.
WIRELESS 7-IN-1 SENSOR MAINTENANCE
REPLACE THE WIND CUP
1. Remove rubber cap and Unscrew
2. Remove the wind cup for
replacement
CLEANING THE UV SENSOR AND
CALIBRATION
• For precision UV measurement,
gentle clean the UV sensor cover
lens with damp micro-fiber cloth.
• Over time, the UV sensor will
naturally degrade. The UV sensor
can be calibrated with a utility
grade UV meter, please refer to
Calibration section in previous page
for about the UV sensor calibration.
REPLACE THE WIND VANE
Unscrew and remove the wind
vane for replacement
Northern
hemisphere
" is showing on the OUT section, it indicates the current sensor's battery power
Moon Phase
New Moon
Waxing Crescent
First quarter
Waxing Gibbous
Full Moon
Waning Gibbous
Third quarter
Waning Crescent
36
Southern
hemisphere
CLEANING THE RAIN COLLECTOR
1. Rotate the rain collector by turning
it 30°anti-clockwise.
2. Gently remove the rain collector.
3. Clean and remove any debris or
insects.
4. Install the collector when it is clean
and fully dried.
CLEANING HYGRO-THERMO
SENSOR
1. Remove the 2 screws at the bottom
of the radiation shield.
2. Gently pull out the bottom 4 shields.
3. Carefully remove any dirt or insects
on the sensor and ventilation fan (do
not let the sensors inside get wet).
4. Clean the shield with water to
remove any dirt or insects.
5. Install all the parts back when they
are clean and fully dried.