Io-Homecontrol® Equipment Wireless Control; Home Page; Adding An Io-Homecontrol® Device - SOMFY V500 PRO io Bedienungsanleitung

V500 io
4.2 io-homecontrol® EQUIPMENT WIRELESS CONTROL
The monitor is equipped with an io-homecontrol® transmitter. It is only compatible with appliances equipped with the
io-homecontrol® radio technology.
It is used to control the following Somfy devices, individually or simultaneously:
- garage door drive,
- lighting receiver,
- roller shutter drive,
- gate drive.
- etc.
This functionality is enabled thanks to a radio channel system identified by columns (see "4.2.1 Home page"). Each channel
corresponds to an individual remote control and can be used to control one or more device(s). There is no limit to the number of
devices that can be controlled by a single channel. To control a channel, you just need to press on it.
Important: Check that the device to be controlled is wireless and within the radio range of the monitor.

4.2.1 Home page

No. Designation
Upper control Open/switch on the
1
Intermediate
control
2
4.2.2 Adding an io-homecontrol® device
To add an io-homecontrol® device, first press
-
in the centre of the screen, if this is the first one you are adding
-
in the top right-hand of the screen, then
Once the adding procedure has been started, the monitor will guide you step-by-step. If in doubt, refer to the io-homecontrol®
device's instructions.
Copyright © 2019 SOMFY ACTIVITES SA. All rights reserved.
4
Function
io-homecontrol® device.
Stop the io-homecontrol® device
in motion.
Set the io-homecontrol® device to
its favourite position.
No. Designation
3
Greyed-out
4
from the home screen, then:
on the left to add your 2nd and subsequent ones
1
2
3
Function
Indoor Close/switch off the
control io-homecontrol® device.
The channel does not currently
channel contain any io-homecontrol®
devices.
EN
EN
11