Inhaltsverzeichnis
Werbung
Fluke 434-II/435-II/437-II
Bedienungshandbuch
Security Summary:
Ad 1. Memory contents erased at power-off. No user access.
Ad 2. Memory contents erased at power-off. No user access.
Ad 3. Save/recall by user. For erase of all data in memory proceed as follows: switch
Ad 4. Flash memory: contents stays available at power off and disconnection of the
Ad 5. Memory contents erased at power-off. No user access.
Ad 6. There are 2 ways of removing measurement data from the Analyzer:
C-2
power on, press SETUP button, press button F4 – USER PREF, press F1 –
FACTORY DEFAULTS, press F5 – YES to confirm.
NiMH accumulator (can be loaded/exchanged with dedicated PC software that is
exclusively available in manufacturing and service). Note: the calibration data is
generated when the analyzer is sent through its calibration process and are
fundamental to the meter operation.
1 - The SD Card is located in the battery-compartment at the rear of the
Analyzer. Open the compartment with a small screwdriver. Push the SD Card in
the direction of the arrow and take it out of the Analyzer. All measurement data
now has been removed from the Analyzer. Avoid touching the contacts of the
Card with you hands. When reinstalling the Card take careful notice of the
indication in the battery compartment.
2 - All measurement data at the SD memory card is erased by formatting it. The
format action occurs via a confirm menu. Do the following key operations with
the SD Card installed in the Analyzer: SETUP, function key F1 – USER PREF,
F4 – FORMAT SD CARD, F5 – YES.
Quicklinks ausblenden:
Werbung
Inhaltsverzeichnis
