Cleaning; Maintenance; Storage; Wall Bracket - Parkside PHSA 20-Li A1 Originalbetriebsanleitung

Cleaning

Do not spray the appliance
with water and do not im-
merse it in water. Electric
shock hazard!
• Keep clean the ventilation slots, motor
housing and handles of the appliance.
Use a damp cloth or a brush. Do not
use cleaning agents or solvents. You
may otherwise irreparably damage the
appliance.
• Always keep the equipment clean. After
using the equipment, it is imperative to:
- Clean the blade (with an oily cloth);
- Oil the blade
shaft with an oil
can or spray.

Maintenance

• Prior to every use, check the appliance
for obvious defects such as loose, worn or
damaged parts. Check that the screws in
the safety knife bar (
• Check covers and safety devices (see
) for damages and correct installa-
tion. Replace as necessary.
• You can smoothen minor nudges in the
cutting teeth yourself using a knife grinder
to sharpen the cutting edges. The trimmer
will only cut well if the teeth are sharp.
• Blunt, bent or damaged knife bars to
be replaced.
Ask our service centre to carry out any
work that is not described in these instruc-
tions. Use only original parts.

Storage

Keep the device in the blade guard (
supplied, dry and out of reach of children.
2) are tight.
14)

Wall bracket

Suspension device on the underside
of the device (12a)
• Using dowels, place one screw at the
desired position on a wall.
• The screw head can have a diameter
of 6 - 8 mm.
• Leave the screw head protruding at a
distance of approx. 10 mm from the
wall.
• You can place the device onto the
screw using the openings on the blade
and pull the device down until it stops.
Suspension device on the blade
guard (12b)
• Using dowels, place two screws
17 mm apart at the desired position on
a wall.
• The screw head can have a diameter
of 4 - 5 mm.
• Leave the screw heads protruding at a
distance of approx. 10 mm from the wall.
• You can place the device onto the
two screws using the openings on the
blade and pull the device down until it
stops
The retention inside the blade
guard prevents oil from dripping
down onto the safety cutter bar and
soiling the floor or wall. Residual oil
collects in the blade guard and can
be poured out into a residual oil
container.
When drilling, be careful not
to damage any supply lines.
Use suitable search devices
to find these or consult an in-
stallation plan for guidance.
GB IE
29