Working Safely; Maintenance/Cleaning - Parkside PHSHE 900 A1 Originalbetriebsanleitung

• Do not saw with the tip of the cutting
equipment.
• Do not saw the bulge at the base of the
branch because this will prevent the tree
from healing.

Working Safely

• Do not use the high pruning saw when
standing on a ladder or in an unsafe
position.
• Do not be tempted to make unconsid-
ered cuts. Doing so may endanger
both yourself and others.
• Children must be supervised to ensure
that they do not play with the equip-
ment.
• Long use of the equipment can result in
vibration-related circulatory disorders
in the hands. However, the length of
use can be extended by using suitable
gloves or taking regular breaks. Note
that a personal tendency for poor cir-
culation, low outdoor temperatures, or
high gripping forces during work will
reduce the length of use.
• Pay attention to the speciied work-
ing angle of max. 60°
ensure that you work safely with the
device.
• Always stand on the slope above or to
the side of the branch to be sawn.
• Hold the device as close as possible
to your body. This will ensure the best
balance.
Maintenance/
Cleaning
Repair and servicing work not
described in this manual should
always be carried by our Service
Centre. Use only original parts.
Carry out the following maintenance and
cleaning work regularly. This will guaran-
tee a long and reliable service life.
•
•
•
•
•
in order to
•
•
•
Pull out the power plug before carry-
ing out any work on the equipment.
Wear gloves while handling the
blades.
Before each use, check the hedge trim-
mer for obvious defects such as loose,
worn or damaged parts. Check the se-
cure seating of the bolts in the cutter bar.
Do not use the unit if the blades are
blunt or worn. This will overstress the
motor and gearbox of the machine.
Check coverings and safety devices for
damage and correct seating. Replace
these where necessary.
Keep the ventilation slots and motor
housing of the device clean. Use a
damp cloth or a brush to do this. Do
not wash down the equipment with wa-
ter, or submerge it in water.
Do not use any cleaning agents or
solvents. These could cause irreparable
damage to the equipment. Chemical
substances can attack the plastic parts
of the equipment.
Clean the cutter bar carefully after
each use.
Wipe it off with an
oily cloth or spray it
with a metal protec-
tive spray.
Keep the hedge trim-
mer dry and covered with the blade
protection supplied and out of reach of
children.
The gears is maintenance free
GB MT
67