Installation - Bimar BG11031 Bedienungsanleitung

Downloaded from www.Manualslib.com
Fax +32 030 9904733

INSTALLATION

• After removing the packing materials, check the integrity of the appliance; if you are unsure, do not
use it and ask for qualified professional help. The packing materials (plastic bags, polystyrene
foam, nails, etc.) must be kept out the reach of children because they are potential sources of
danger; but dispose of them in accordance with current law.
• Before connecting the appliance, check that the voltage shown on the data plate matches that of
your electricity, and that the electric plug is grounded. In the event of incompatibility between the
electric outlet and the plug of the appliance, have the outlet replaced with another more suitable
type by professionally qualified personnel, who will make sure that the section of the wires of the
outlet is appropriate for the absorbed power of the appliance. In general, the use of adapters or
extension cords is not recommended; if their use is indispensable, they must conform to existing
safety standards and their current capacity (amperes) must not be less that the maximum of the
appliance.
Wall installation
• If the appliance is fitted to a wall, the same must be made of masonry and/ or of heat-resistant
material (not of wood or synthetic material which rapidly heats up), care should be taken not to fit
panels where water pipes or electrical wiring might be embedded in the walls; follow the
indications below for installation:
1) The heater must be installed at least 1,8 m above the floor.
2) so it is horizontal, to avoid it overheating or damaging the heating elements
3) far from other sources of heat, inflammable materials (curtains, carpets, etc.), inflammable
gases or explosive materials (spray cans) and from materials that can deform on exposure to
heat
4) at the minimum distances from walls (always so long as they are masonry or brick) indicated
in figure n.2; these distances must be increased at least 3 times for other materials, but it is a
good idea to use a professionally qualified installer; the heater must be installed at least 1,8m
above the floor.
5) not below electrical outlets.
- Attach the heater to the wall using n.5 screws provided, use the holes of the control box (see fig.2).
• Make sure that the electric cord is correctly positioned, inset the electric cord through the guide
(right or left) not touching hot or sharp surfaces and not wrapped around the appliance or twisted.
• To orient the infrared radiant element and heat in the most convenient way, adjust the inclination of
the heating part (angle = 45° max).
• Do not use the appliance with a timer or a programmer or with a system that can switch on the
appliance automatically, to avoid risk of fire, since a fire risk exists if the heater is covered or
positioned incorrectly.
• All repairs should be made by a competent qualified electrician. In any case you should return the
appliance to this service.
manuals search engine
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar
(Italy). The pages must be reproduced and folded in
order to obtain a booklet A5 (+/- 148.5 mm width x 210
mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't
change the page numbering. Keep the language
integrity.
9/24
Assembly page 9/24