Commissioning - Kessel Pumpfix Einbau- Und Betriebsanleitung

5

Commissioning

5.1 Automatic operation
Checking the battery voltage
The control unit checks the battery voltage 2x daily and signals a battery error (potential-free contact "fault") if the voltage
falls below a certain level. Optical and acoustic warning signals appear on the control unit every 20 seconds.
SDS self-check
The control unit has an automatic self-check, which performs a functional check of the connected movable components
automatically. Even if no backwater events occur, the system's readiness is checked.
Preset test cycle:
every 7 days (1-7 day interval is possible)
10:00
5.2 Acknowledge alarm
The control unit displays (alarm) messages as follows:
the alarm LED flashes red
an error message appears in the display,
an acoustic signal
Press acknowledge alarm button for 3 second.
Acoustic signal is muted, LED stops flashing.
5.3 Overview of configuration menu
Overview menu
The control menu is split into four menu areas:
0 System info - selected system, configured sensors, cur-
rent measured values; if applicable, events or error mes-
sages
1 Information - display of the operating data (e.g. voltage,
current measured values, logbook or set parameters)
2 Maintenance - maintenance-relevant tasks (e.g. switch
pump(s) on/off), self-diagnosis, maintenance date and inter-
val)
3 Settings - setting of the switching levels, sensor and sys-
tem configuration, configuration of the modem interface,
resetting the control unit
Pumpfix/Ecolift menu texts
0. System info
1. Information
1.1 Hours of operation
1.2 Log book
1.3 Control type
1.4 Maintenance date
1.5 Current measured values
* The menu for USB data exchange is displayed on pressing the ESC button in the System Info area or after successful
detection of the USB flash drive.
016-004_01
(1)
1.1.1 Total running time
1.1.2 Power outage
1.1.3 Energy usage
1.1.4 Backwater phase
1.1.5 Backwater occurrences
1.1.6 Flap operating cycles
1.1.7 Run time pump
1.1.8 Operating cycles
1.1.9 Overvoltage
1.1.10 Undervoltage
1.4.1 Last maintenance
1.4.2 Next maintenance
1.5.1 Battery voltage
Installation and operating instructions
Number of the menu item
h 0 - 999,999.9
mm:hh - dd.mm.yy
mm:hh - dd.mm.yy
V 0 - 99.9
23 / 84