Measurement Memory; A) Measurement Storage; B) Retrieving Measured Values; C) Clearing The Measurement Memory - VOLTCRAFT GT-6000 Bedienungsanleitung

10. Measurement memory

The GT-6000 is equipped with a measurement memory for storing the measured values of 999 test objects. The
measurement data are buffered via an integrated lithium button battery (CR2032). The data will not be lost when the
batteries are replaced.

a) Measurement storage

• Once the test sequence is complete and the test result is available, press the save button (13). The displayed
measured values are saved in the first free memory space.
• Saving is confirmed by the "STORE" symbol and the memory space number appearing on the display.
• The save button (13) is locked until another test is performed to prevent dupli-
cates being saved.
• The memory space number is automatically increased by one each time a
value is saved. "FULL" appears on the display when all 999 memory spaces
have been used.

b) Retrieving measured values

• Press the folder button (14) to retrieve the saved measured values with the corresponding memory space number.
The "RECALL" symbol appears on the display.
• The folder button (14) switches to the next memory space, the save button (13) switches back to the previous
memory space.

c) Clearing the measurement memory

• Press the folder button (14) to retrieve the saved measured values with the corresponding memory space number.
The "RECALL" symbol appears on the display.
• To clear the entire measurement memory, press and hold the save button (13) and the folder button (14) at the
same time until the counter value is reset to zero. The display shows "no dAtA" when the memory is empty. Indi-
vidual memory spaces cannot be cleared.

d) Reading out the measurement memory via USB interface

• The measured values can be downloaded from the GT-6000 to a Windows
load program. The data are transferred via the USB interface. When the USB interface is activated, automatic
shut-offs cannot occur. Auto power-off is thus deactivated.
Remove all connection cables and test objects from the GT-6000. Only the interface cable may be
connected.
• The driver and the download program must be installed on the computer before the GT-6000 can be connected
via the USB interface.
60
-compatible computer using a down-
®