Control Circuit Wire Gauges And Tightening Torques - Omron Q2A Installations- Und Bedienungsanleitung

1 English
*1 Connect peripheral options to terminals -, +1, +2, B1, and B2.
*2 For circuit protection, the main circuit is separated from the surface case that can touch the main circuit.
*3 The control circuit is a Safety Extra-Low Voltage circuit. Separate this circuit from other circuits with reinforced insulation. Make
sure that the Safety Extra-Low Voltage circuit is connected as specified.
*4 Reinforced insulation separates the output terminals from other circuits. Users can also connect circuits that are not Safety Extra-Low
Voltage circuits if the drive output is 250 Vac 1 A max. or 30 Vdc 1 A maximum.
■

Control Circuit Wire Gauges and Tightening Torques

Use shielded wire for control circuit terminal wiring. Use crimp ferrules on the wire ends for more reliable wiring.
14
Figure 1.2 Standard Connection Diagram
TOMPYEUOQ2A03C AC Drive Q2A Installation and Operation Instructions