Standard Accessories; Optional Accessories; General Conditions Of Use - Corghi EM 9280 Betriebsanleitung

STANDARD ACCESSORIES

The following parts are supplied together with the machine.
Weight pliers
Calliper for wheel width measurement
Hexagon wrench, size 4
Hexagon wrench, size 6
Open wrench CH 10
Hexagon wrench, size 10
Calibration weight
Wheel balancer power supply cable
Monitor power supply cable
Small cone
Medium cone
Large cone
Small wheel fixing cap protection
Spacer cap
Small wheel fixing cap
Threaded hub
Quick fastener ring for locking wheel

OPTIONAL ACCESSORIES

Please refer to the relevant accessories catalogue.

GENERAL CONDITIONS OF USE

The equipment is intended for professional use only.
CAUTION
Only one operator at a time can work with the machine.
The wheel balancers described in this manual must be used exclusively to measure the extent
and position of car wheel unbalances, within the limits specified in the Technical specification
section.
CAUTION
Any use of the machine other than the described use is to be considered as improper and
unreasonable.
WARNING
Do not start the machine without the wheel locking equipment.
WARNING
Do not clean or wash the wheels mounted on the machine with compressed air or jets of water.
80 Operator's manual EM 9280 - EM 9280 C CompactLine