Operation; Check The Battery Status; Using The Battery; Connecting The Battery To The Machine - Epropulsion E-Serie Bedienungsanleitung

2 Operation

2.1 Check the Battery Status

Do not remove the protective foam on the battery base. The foam protects the
battery from corrosion and covers fixings.
If the alarm indicator is on, refer to Section 2.4 LED Indicators, Section 2.5 Buzz-
er, and Section 3 Troubleshooting to deal with the problems.
During this operation, the battery has no output.
Before each use of the battery, please check the battery status by following steps:
Short press (not turn on) the power button on the battery or the remote switch. The
battery indicator will light for 5 seconds to show the battery status (battery level or
warnings).

2.2 Using the Battery

2.2.1 Connecting the Battery to the Machine

When connecting the power cables, please pay attention to the positive and neg-
ative terminals. Never mix up the positive terminals with negative terminals.
Avoid battery short-circuit during connection.
If it is connected to ePropulsion outboard motor, and the power cable or commu-
nication cable is abnormally connected, the outboard motor will stop.
Before connecting the battery to the machine (outboard, etc.), make sure that the bat-
tery power button is turned off and follow these steps:
1. Connect the power cable of the machine to the battery.
2. When connecting with ePropulsion outboard motor, in order to better obtain the
battery information please use the communication cable (purchased separately)
to connect the machine with the battery (refer to figure 2-1).
3. If you need to use the ePropulsion outboard with a wired remote control, tiller, side
mount control or other control systems, it recommends you use a Y-type commu-
nication cable (purchased separately) to connect your equipment (refer to figure
2-2).
10