Installation Of The Circulating Pump - Valeo Thermo AC Einbau- Und Betriebsanweisung

Thermo AC 2nd generation Installation of the heater - fitting of important assemblies

11.3. Installation of the circulating pump

Consider the information regarding the installation provided in the
documentation of your circulation pump. Note the installation position!
NOTE:
The pump ports and connection lines from the water intake and water
outlet must be flush (no stress).
ATTENTION:
If the pump is not controlled by the heater, its operation is to be en-
sured by all means during whole heater operation (heating opera-
tion and purge cycle). At least turn on the Thermo AC 200 and
pump at the same time, but ensure the operation of the pump by an
appropriate control circuit at least 2 to 3 min. after switching-off
the heater.
49