Applicable Controls - Toshiba MMU-AP0071MH Installations-Handbuch

7

APPLICABLE CONTROLS

When using the equipment for the first time, the remote controller will not accept any commands for a short
period of time.
• Automatic address
• While automatic addressing no operations can be performed on the remote control.
• Automatic addressing will take a maximum duration of 10 minutes (generally 5 minutes).
• Upon turning on the unit after completion of automatic addressing, a maximum period of
10 minutes (generally 3 minutes) are required prior to the start up operation of the outdoor unit.
All indoor units are shipped from factory as standard. Change if necessary.
To change the setup use the main remote controller (wired remote controller).
* The setup change for wireless remote controller, sub remote controller or a unit without a controller (Centrally
controlled.) is not possible. In such cases, temporarily install a separate main remote controller.
Applicable control setup
Basic operation procedure for setup change
Change the setup while operation of the equipment is stopped.
(Be sure to stop the operation of a set.)
Procedure
1
2
3
4
5
6
Downloaded from www.Manualslib.com
SET CL TEST
Push the , and buttons simultaneously for 4 seconds or more, after a while, the display part flashes
as shown in the figure.
Check that the displayed item code is [10].
• If the item code indicates any characters other than [10], push the
button to erase the display and retry the operation from the first step.
TEST
(For some time after the button has been pushed, the operation
of the remote controller cannot be accepted.)
(In a group control, the firstly displayed
indoor unit No. becomes the center unit.)
UNIT
Each time the button is pressed, the indoor unit No. in the group control is displayed consecutively.
Select the indoor unit that requires a change to the setup.
During this time the indoor unit that is selected can be
confirmed as the louver and fan will be operated.
TEMP.
Using the buttons, select the item code [
TIME
Using the buttons, select set data [
SET
Push the button. During this time, if the display changes from flashing to permanently on, the setup is
complete.
• To change the setup of an indoor unit that is not selected, restart operation from Procedure
• To change to a different setup within the selected indoor unit, restart operation from Procedure
CL
Pushing the button clears the set up contents which has been set. In this case, restart from Procedure
When the setup is finished, push the
TEST
Pushing the button deletes the display and returns the status to the
normal stopped status.
TEST
(For a period of time after the
controller will not accept any commands.)
manuals search engine
NOTIFICATION
6
1
6
Description
**
].
****
].
TEST
button. (The setup is configured.)
button has been pushed, the remote
18
CODE No.
UNIT No.
R.C. No.
TEMP. ON / OFF
TIMER SET FAN MODE
TIME SWING/FIX VENT
FILTER
RESET TEST SET CL UNIT
∗
TEST
SETTING
UNIT No.
R.C. No.
(* The display changes according
to the indoor unit model.)
∗∗ ∗ ∗
UNIT No.
∗ ∗ ∗∗
R.C. No.
2
.
3
.
3
2
5
CODE No.
∗∗
CODE No.
2
.