Leica DMLS Bedienungsanleitung Seite 15

Filter magazine*/Filter holder*
Set the specimen stage and the condenser at
the top position (11.1; 11.2). Push the filter
magazine (11.4) or filter holder (12.3) onto the
base of the microscope and align by rotation
(not for DM LSP!).
Filter magazine only: Lift the back of the
magazine slightly and rotate until the catch (11.4)
clicks into the stand at the front, then push the
magazine towards the back so that its position is
fixed. Apply adhesive filter labels to switching
levers.
Fluorescence filter cube*, assembly
Pull the filter slide (31.10) out of the illuminator.
Lift off lid (14.1). Insert filter systems (max. 2) as
follows:
!
Take care to avoid making finger marks.
The lettering of the filter system, e. g. A 513824
(14.5) must point to the front, so that the dovetail
mount (14.5) points downwards.
Fig. 13 Interchangeable object holders*
1 for 2 specimens 26 mm x 76 mm, 2 One-hand object holder
for 1 specimen, 3 Mountable rotary stage
Downloaded from www.Manualslib.com
Attention:
1
2
manuals search engine
!
Put the filter system onto the round steel rod
(14.2) so that the curved laminated spring snaps
into position. If you try tilting the whole slide,
the filters must not fall out.
Inserting the filter slide*
Replace the lid (14.1) and rotate the slide until
the side without a hole faces you. Push the slide
in to the illuminator from the left or the right
(Fig. 39).
Stick the adhesive labels corresponding to the
filter system, e. g. A, outside on the slide or the
fluorescence illuminator. Use of adjustment lens
(14.4) → p. 39, the enclosed metal plate (25.5 and
31.11) → p. 16.
Fig. 14 Assembly of fluorescence illuminator*
1 Lid, 2 Steel rod and spring, 3 Filter system, 4 Adjustment lens F,
5 Dovetail in filter system
3
Attention:
1
3
2
4
5
15