Connecting The Power Supply; Connecting The Antenna; Preparing The Remote Control - Sonoro SO-220 Bedienungsanleitung

1. Open the battery compartment cover on the
back of the device with a small coin (Fig. 8).
2. Insert the supplied battery with the label side
up.
3. Insert the battery compartment cover and close
with a small coin.

7.3 Connecting the power supply

Power is supplied to the device via the AC adapter
(included). The AC adapter with universal adapter
must be connected before use.
L WARNING!
Risk of injury from incorrect handling!
Risk of electric shock from improper handling of
the AC adapter with universal adapter.
– Make sure that the AC adapter and universal
adapter are always firmly connected to each
other.
– Pull the AC adapter straight out of the socket so
that the adapter does not break off the
mounting bracket.
L NOTICE!
Material damage occurs from an incorrect vol-
tage connection!
Connection values that exceed the maximum
allowable values of the device can irreparably
damage the device.
– Only use the AC adapter included.
– Only operate the device if the electrical voltage
indicated on the AC adapter matches the
voltage of your power outlet.
Fig. 9: Installing the universal adapter
1. Push the universal adapter onto the AC adapter
until it clicks into place (Fig. 9).
2. Insert the plug connector of the AC adapter into
the 15.5 V, 2.9 A DC port at the back of the
device.
58
3. Insert the mains plug into the socket.

7.4 Connecting the antenna

The scope of supply contains a cable antenna and a
rod antenna. For optimum radio reception, you must
use one of the two antennae.
1. Screw the desired antenna located on the back
of the device to the DAB/FM antenna connector.
Fig. 10: Aligning the cable antenna
2. Unfold the cable antenna or pull the arms of the
rod antenna apart and align the antenna so that
you have the best possible reception.
i
For good FM/DAB radio reception, the two ends of
the cable antenna should form a "T" (dipole) with
the connecting cable.
– Fig. 10/A: Recommended alignment for FM
– Fig. 10/B: Recommended alignment for DAB
For even better reception, attach the cable to a
suitable house antenna.

7.5 Preparing the remote control

Fig. 11: Inserting the battery into the remote control
1. Open the battery compartment on the remote
control with a small coin (Fig. 11).
2. Insert the supplied button cell (CR2032, 3 V)
with the label (+) side up.