•
The programme starts, the lid locks, the
indicator
•
The drain pump can operate for a short time
at the beginning of the washing cycle.
After approximately 15 minutes from
the start of the programme:
•
The appliance adjusts automatically
the programme duration agree with
the laundry load.
•
The display shows the new value.
STARTING A PROGRAMME WITH THE
FERTIG IN/ FINI DANS OPTION
1. Touch the button
the number of hours in which you want the
washing cycle to be finished.
The display shows the number of hours you set
(e.g.
) and the indicator above the button
on to show that his option is active.
2. Touch the button
•
The door is locked.
•
The appliance starts the countdown.
•
When the countdown is completed, the
programme starts automatically.
You can cancel or change the set of
the Fertig in/ Fini dans option before
you touch the button
touching the button
cancel the Fertig in/ Fini dans option.
To cancel the the Fertig in/ Fini dans option:
a. Touch the button
to pause. The indicator of button
flashes.
b. Touch the button
above this button goes off.
Touch the button
programme immediately.
When using liquid detergents in
combination with the Fertig in/ Fini
dans option, add the liquid detergents
with a dosing ball (supplied by the
detergent's manufacturer).
INTERRUPTING A PROGRAMME AND
CHANGING THE OPTIONS
You can change only some options before they
operate.
1. Touch
.
is on.
again and again to choose
:
. After
you can only
to set the appliance
until the indicator
again to start the
The indicator of this button flashes.
2. Change the options. If you change any option
the Fertig in/ Fini dans option (if set) will be
disabled.
3. Touch
again.
The programme continues.
CANCELLING A PROGRAMME
1. Press the button
cancel the programme and to deactivate the
appliance.
2. Press the same button again to activate the
appliance. Now, you can set a new washing
programme.
Before starting the new programme
the appliance could drain the water. In
this case, make sure that the detergent
is still in the detergent compartment, if
is
not fill the detergent again.
OPENING THE LID
While a programme (or the
appliance lid is locked. The indicator
CAUTION! If the temperature and
level of the water in the drum are too
high, you cannot open the lid.
To open the lid during the first minutes of the
cycle (or when the
1. Touch the button
2. Wait a couple of minutes until the indicator
goes off.
3. You can open the lid.
4. Close the lid and touch the button
The programme (or the
AT THE END OF THE PROGRAMME
•
The appliance stops automatically.
•
The acoustic signal operates (if it is activated).
•
In the display
•
The indicator of the button
•
The lid lock indicator
unlocking) and then goes off.
•
You can open the lid.
•
Remove the laundry from the appliance. Make
sure that the drum is empty.
•
Press the button
deactivate the appliance.
•
Close the water tap.
for some seconds to
) operates, the
operates) :
to pause the appliance.
) continues.
comes on.
goes off.
blinks (when the lid is
for some seconds to
is on.
again.
15