Makita DTW700 Betriebsanleitung Seite 8

Changing the application mode
Changing the impact force
You can change the impact force in four steps: 4 (max), 3 (hard), 2 (medium), and 1 (soft).
This allows a tightening suitable to the work.
7KH OHYHO RI WKH LPSDFW IRUFH FKDQJHV HYHU\ WLPH \RX SUHVV WKH EXWWRQ
<RX FDQ FKDQJH WKH LPSDFW IRUFH ZLWKLQ DSSUR[LPDWHO\ RQH PLQXWH DIWHU UHOHDVLQJ WKH VZLWFK WULJJHU
NOTE: <RX FDQ H[WHQG WKH WLPH WR FKDQJH WKH LPSDFW IRUFH DSSUR[LPDWHO\ RQH PLQXWH LI \RX SUHVV WKH EXW-
ton or .
Fig.7
Application mode
(Impact force grade displayed on panel)
4 (Max)
3 (Hard)
2 (Medium)
1 (Soft)
: The lamp is on.
NOTE: When none of the lamp on the panel is lit, pull the switch trigger once before pressing the button
NOTE: $OO ODPSV RQ WKH VZLWFK SDQHO JR RXW ZKHQ WKH WRRO LV WXUQHG R WR VDYH WKH EDWWHU\ SRZHU 7KH LPSDFW IRUFH
JUDGH FDQ EH FKHFNHG E\ SXOOLQJ WKH VZLWFK WULJJHU WR WKH H[WHQW WKDW WKH WRRO GRHV QRW RSHUDWH
.
Maximum blows
-1
2,700 min (/min)
-1
2,400 min (/min)
-1
1,700 min (/min)
-1
1,000 min (/min)
8 ENGLISH
Purpose
Tightening with the maximum force and
speed.
Tightening when the force and the speed
are desired.
Tightening with less force and speed than
Max mode (easier to control than Max
mode).
Tightening when the force and the speed
are desired.
7LJKWHQLQJ ZKHQ D JRRG ¿QLVKLQJ LV
needed.
7LJKWHQLQJ ZKHQ \RX QHHG JRRG FRQWURO
power.
Tightening with less force to avoid screw
thread breakage.
7LJKWHQLQJ ZKHQ \RX QHHG ¿QH DGMXVWPHQW
with small diameter bolts.
.