Multiplex Easystar 3 Benutzerhandbuch Seite 19

Assembly instructions
38. Pre-flight checks
For the first flight wait for a day with as little breeze as possible; the
evening hours often offer calmer conditions.
Important: It is essential to carry out a range-check before the first
flight! Please follow the instructions laid down by your RC system
manufacturer.
The transmitter battery and flight pack must be fully charged in accordance
with the manufacturer's recommendations.
If you are unsure about any point, do not fly the model! If you cannot
identify and cure the problem, send the whole RC system (including
battery, switch harness and servos) to your system manufacturer for
checking.
39. Maiden flight ...
Important: Do not attempt any hand-glides with this model!
The aircraft is designed to be hand-launched (always into wind). If you
are a beginner to model flying, we strongly recommend that you ask an
experienced modeller to help you for the first few flights. Once the model
has reached a safe height, adjust the control surfaces using the trims
on the transmitter, so that the model flies straight and level "hands-off".
With the aircraft flying at an adequate altitude, check how it responds
when the motor is switched off, so that you are familiar with its behaviour
on the glide. Carry out repeated simulated landing approaches at a safe
height, as this will prepare you for the real landing when the battery is
discharged. Avoid flying tight turns at first, especially close to the ground,
and in particular during the landing approach. It is always better to land
safely some distance away than to risk a crash by forcing the model back
to your feet. If you have no prior experience in model flying, please take
the time to read through the section entitled "The basics of model flying".
Important: Before every flight, check that the battery, the wings and
the tail panels are attached and firmly seated. Check in turn that each
control surface is operating correctly!
The Multiplex Modellsport Team
EN
19