IBIZA LIGHT LMH330LED Bedienungsanleitung Seite 5

Master/Slave Fixture Linking
1. Connect the (male) 3 pin connecter side of the DMX cable to the output (female) 3 pin connecter of the first
fixture.
2. Connect the end of the cable coming from the first fixture which will have a (female) 3 pin connecter to the input
connecter of the next fixture consisting of a (male) 3 pin connecter. Then, proceed to connect from the output as
stated above to the input of the following fixture and so on
Mounting
ORIENTATION
This fixture may be mounted in any position provided there is adequate room for ventilation.
RIGGING
It is important never to obstruct the fan or vents pathway. Mount the
fixture using, a suitable C or O type clamp. Adjust the angle of the
fixture by loosening both knobs and tilting the fixture. After finding the
desired position, retighten both knobs.
When selecting installation location, take into consideration lamp
replacement access and routine maintenance.
Safety cables must always be used.
Never mount in places where the fixture will be exposed to rain, high
humidity, extreme temperature changes or restricted ventilation.
4. OPERATING INSTRUCTIONS
4.1 Navigation through the Control Panel
Access control panel functions using the four panel buttons located directly underneath the LCD Display.
Button Function
<MODE/ESC> Used to access the menu or to return to a previous menu option
<UP> Scrolls through menu options in ascending order
<DOWN> Scrolls through menu options in descending order
<ENTER> Used to select and store the current menu or option within a menu
When a menu function is selected, the display will show immediately the first available option for the selected menu
function. To select a menu item, press <ENTER>.
4.2 Menu map
Press the <MODE/ESC> button repeatedly until you reach the desired menu function. Use the <UP> and <DOWN>
©Copyright LOTRONIC 2012
Often, the set up for Master-Slave and Stand-alone
operation requires that the first fixture in the chain
be initialized for this purpose via either settings in
the control panel or DIP-switches. Secondarily, the
fixtures that follow may also require a slave setting.
Please consult the '' Operating Instructions» section
in this manual for complete instructions for this type
of setup and configuration.
LMH350LED Page 5