Rizzoli S Serie Gebrauchsanweisung Seite 96

2.14 PLINTH REGULATION
The plinth of the cookers and thermal cookers can
be regulated in order to match the space in which
the device is inserted. It is possible to adjust the
level of the device by operating on the levelling
pins that can be regulated in height. To regulate
easily the pins, it is necessary to remove the wood­
box (see chapter 2.13). Now, it is possible to reg­
0-20
0-20
mm
mm
Picture 17 – Regulation of the height of the stove with hex key through the levelling pins
2.15 ELECTRIC CONNECTIONS (MODELS WITH OVEN)
The electric connection of the cookers and ther­
mal cookers allows the lighting of the oven lamp.
The connection to AC power must be done by ex­
perienced people and according with existing laws.
The installer is responsible of the correct connec­
tion according with safety rules. To make the con­
nection, you have to connect an electric cable to
the terminal board placed in the rear side of the
cooker. Must be done the correct connections of
line, neutral and earth as described in picture 19.
The cable and every other electric device added
must be dimensioned for the electric load to sus­
tain and must not be in contact with points 50° C
hotter than ambient temperature.
ulate singularly each pin placed in the plinth near
the corners, so that the adjustment of the device is
correct. For the regulation of the pins, use an hex
key n.6: once you have reached the desired height,
fix the locknut with a n.13 key (see picture 17). The
pins have an excursion of 20 mm.
N. 6
N. 6
N. 13
N. 13
Picture 18 - Position of the terminal board for the
connection to the network.
94