Alarm Messages - Binder C 150 Serie Kurzanleitung

Set-point entry
Set-point entry temperature and CO
Normal Display
D isplay of the
values of
and CO
O perating mode
Set-point entry temperature
Set-point entry
Set-point entry
Set-point entry, confirm with "Mode"
GB
2
actual
temperature
concentration
2
HAND
CO
2

Alarm messages

When operational faults occur, the controller triggers visual and audible alarm signals. The LED "ALARM"
(general alarm) lights up.
If more than one alarm signal is sent simultaneously, they are displayed in a cycle. Alarms 995 to 999 take
priority over all other displays of the controller.
Alarms are displayed immediately when the fault occurs. After opening the unit door or switching on the
C 150, tolerance range alarms are suppressed for the selected delay times.
Set value of the safety controller exceeded
Temperature tolerance range alarm
CO tolerance range alarm
2
Door open
CO pressure too low
2
Failure of CO sensor
2
Failure of temperature sensor for door heating
Failure of temperature sensor for safety controller
Failure of temperature sensor for interior heating
CO sensor not connected
2
Sterilization program started with operating mode HAND locked (LOCK)
Sterilization program started with the CO sensor still plugged-in.
Resetting the alarm messages
Eliminate the cause of the alarm or wait until the unit compensates for the error. The visual alarm
disappears, when the cause of the fault has been remedied or the monitored operating function returns
within its tolerance limits. Press the "EXIT" button to switch off the audible alarm signals.
Zero-voltage relay alarm output
The zero-voltage relay alarm output permits transmission of the alarm e.g., to a central monitoring system.
The maximum loading capacity of the switching contacts must NOT exceed 24 V AC/DC 2.5 Amp.
Copyright © 10/2012
BINDER GmbH
or
2
Art. No. 7001-0235