Switching Commands - G&D DVIMUX4-USB Installation Und Bedienung

Enabling the »Switch« mode
IMPORTANT: The Service port of the KVM switch can be used to operate the setup
menu as well as to switch between the channels with a serial device.
Switching of channels via the serial device is possible only if the
If necessary, change the standard mode (see page 28) of the Service port to this mode if
you want to switch channels via the serial device immediately after starting the KVM
switch.
An alternative to switching to the
operation.

Switching commands

The following commands are provided for switching the channel:
Command
1!
2!
3!
4!
<!
>!
ADVICE: Use the » « command to show the currently accessing channel.
?!
NOTE: The serial device carries out the command directly after it is sent.
A message (see below) informs the serial device concerning the success or failure
of the switching of channels.
Switch mode is to enter the »
Channel
1
2
3
4
switch to previous channel
switch to next channel
Switching
mode is active!
Switch
! « command during
G&D DVIMUX4-USB · 11