Startup; System Startup; Status Displays - G&D DVIMUX8-OSD-USB Installation Und Bedienung

Startup

Startup
You can operate the KVM switch immediately after its installation.
How to turn on the KVM switch:
1. Turn on the Power switch on the back panel of the KVM switch.

System startup

After you turn on the KVM switch, the console monitor displays information about the
System Startup . In addition to the installed firmware, you are also informed if key-
board and mouse are detected.
ADVICE:
You can press
the process.
If the KVM switch is ready for operation, the

Status displays

The LEDs on the front panel of the KVM switch highlight the device's current oper-
ational status:
Section LED
CPU 1 ... 8 Active
Status
User Active
Status
7 · G&D DVIMUX8-OSD-USB
Pause to pause the process. Press any other key to continue
Status Meaning
on All inputs are forwarded to the computer of this channel.
In the default settings of the KVM switch, data of devices
connected to the »USB 2.0 Devices« interface are for-
warded to the computer of this channel, too.
An additionally flashing Active LED (see below) of
another channel shows that USB data is permanently
switched to another channel.
flashing The devices connected to the »USB 2.0 Devices« interface
are permanently switched to this channel (Pinning).
off The channel is currently inactive.
on The computer is ready for operation.
off No computer is connected or the computer is turned off.
on The keyboard is initialised successfully.
blinking The console keyboard cannot be found.
on The KVM switch is supplied with the necessary voltage.
off The KVM switch is turned off or is not supplied with the
necessary voltage.
If necessary, check the proper connection of the power
supply cable.
Select Computer or Login dialogue opens.