Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
How to select the scancode set for PS/2 keyboards:
1. Press
Ctrl+Num
(standard) to open the On-Screen Display.
2. Press
F1
to open the menu.
3. Use the
Arrow keys
to select
4. Use the
to select
Arrow keys
5. Press
F1
to save your settings.
6. After a restart the setting applies to the KVM switch.
Adjusting the transparency of the on-screen display
In the default settings of the KVM switch, the on-screen display covers parts of the
screen content.
By enabling a transparency level, the image sections covered by the OSD are visible up
to a certain degree (see below).
How to adjust the transparency of the on-screen display:
1. Press
(standard) to open the On-Screen Display.
Ctrl+Num
2. Press
F1
to open the menu.
3. Use the
Arrow keys
to select
4. Use the
Arrow keys
following options:
Off:
screen content is covered
Low:
screen content slightly visible (6,25 %)
Average:
screen content semi-visible (12,5 %)
High:
screen content highly visible (25 %)
5. Press
F1
to save your settings.
Opening the On-Screen Display by mouse
In the default configuration, you can only open the On-Screen Display with the pre-
set key combination.
If a Microsoft »IntelliMouse Explorer« or another compatible mouse is connected to
the KVM switch, you can use the mouse keys
NOTE:
If you access the On-Screen Display by mouse, you cannot use Microsoft's
»IntelliMouse Explorer« or another compatible mouse when performing the Step-
scan function (see page 39).
Console Setup
and press
and press
Scancode Set
Console Setup
and press
to select
OSD Transperancy
Enter
.
to select scancode set
Space
Enter
.
and press
Space
to select one of the
4
and
5
to access the On-Screen Display.
G&D DVIMUX8-OSD-USB · 38
Configuration
or
.
2
3
Werbung
Kapitel
Inhaltsverzeichnis
