Maintenance, Care And Repair; Regular Cleaning; B) Replacing The Rotors - Reely 51 80 07 Bedienungsanleitung


15.

Maintenance, Care and Repair

a) Regular Cleaning
The „Mini-Copter MC 120" is a very simple but nonetheless well-designed flying device. There are no mechanical parts that need to be
lubricated or require special maintenance. However, after each flight operation you should clean the „Mini-Copter MC 120" of possible dirt
(wool strings, dust, etc.).
For cleaning, use a dry or slightly damp cloth and avoid contact between water and the electronics, rechargeable battery and motors.
Do not fly without covering the electronics. Please ensure that no moisture enters the inner central piece. Never fly when it is raining!

b) Replacing the Rotors

If a rotor is damaged in a crash or other action, replace it immediately. This also applies if there are any fine tears or grazing in the rotor. Due
to the high speed, material parts could come loose if the rotors are damaged and this could lead to damage to or endangerment of the
environment.
To replace a rotor, pull the damaged rotor from the motor shaft and replace it with a new one. The rotors must not be pushed completely onto
the motor shaft. Keep about 0.5 mm distance from the motor housing. Figure 11 shows the place where the rotor must be attached.
For reference, put the Mini-Copter MC 120 onto your work surface with
the model LED (see arrow) pointing to the front right.
The front motors (figure 11, items 1 and 2) are at the „front" for this
model and must have red rotors. Motor 1 turns counter clockwise, motor
2 turns clockwise.
The rear motors (figure 11, items 3 and 4) must have black rotors. Motor
3 turns clockwise, motor 4 turns counter clockwise.
Do not bend the motor shafts. Bent motor shafts (e.g. from crashes)
influence the flight properties negatively due to he vibration that results
and the irritation to the sensors. Motors with bent motor shaft must be
replaced.
Figure 11
52