CASO DESIGN SousVide Center SV 900 Original Bedienungsanleitung Seite 34

Setting the cooking time:
To set the cooking time, press key " " (key 2). The LED display will indicate the time and
flash. The default value of 02:00 is displayed. Press the key (+/-) to increase / reduce the
time. Time can be selected as follows: 00:00–99:00 hours.
Use the keys (+/-) to set the cooking time to the desired value. By keeping the key
pressed, you can change the numbers more quickly.
When the desired time is reached, after 5 seconds the display will automatically display
the bin temperature.
Starting the cooking:
Please place the vacuum-packed foods into the bag holder and drainer into the bin.
Make sure that the food is completely covered with water.
Now close the lid carefully.
Select the cooking time and temperature and press key "
of the water. An alarm sounds when the bin starts heating.
When the water reaches the selected temperature, 3 alarms will sound, and the actual
cooking starts. The selected cooking time will start at this time point. When the cooking
time is completed, the alarm will sound again. The food can then be withdrawn.
► Risk of scalding! Carefully remove the food.
To check the remaining time during the cooking process, press key " " (Key 2) at any
time.
You can change both cooking temperature and time during cooking. Proceed again as
described under "Setting the cooking time".
However, you can use the device also without setting the cooking time. Press key ' ' (Key
2) to activate the device. The unit will operate continuously without time limit if the cooking
time is set to 00:00.
To stop or interrupt the cooking, press key "
To interrupt the power supply and switch off the device, press ' ' (Key 1) for one second.
To check the input made via the individual keys, press the respective key for a little more
than half a second.
► If the device should indicate "E001" in the LED display after switching on even though
the water filled in is above the minimum level, please add some salt to the water and stir
well.
Warning
Note: E001
" (Key 4) to start the heating
" (Key 4).
34