Special Parameters For Bg30/1400/R Series - Roger Technology B70/1DCHP Anweisungen Und Hinweise Für Die Installation

15

Special parameters for BG30/1400/R series

even in the event of power failure. The control unit allows independent management of speed,
acceleration, deceleration and the safety devices used in the system.
force to impede manual movement of the gate.
As a result, prolonged operation may drain the battery when operating under battery power.
than 3 cm is detected, the control unit initiates a position recovery procedure (see chapter 20).
NOTE:
Selecting automation system model
WARNING!
The automation system will no longer function effectively and it will not be possible to diagnose faults.
N.B.: in the event of a reset to restore the default parameters, this parameter must be set again manually.
BG30/1400/R - REVERSIBLE motor for gate leaves up to 1400 kg .
Setting deceleration during opening
Setting deceleration during closing
01= the gate decelerates near the limit switch ... 05= the gate decelerates long before the limit switch.
Setting start acceleration during opening
Setting start acceleration during closing
01= the gate accelerates rapidly at start of manoeuvre ... 05= the gate accelerates slowly and progressively at
start of manoeuvre.
Setting opening speed
N.B.:
Setting closure speed
N.B.:
01= 6 m/min ... 10= maximum speed.
N.B.: to set the constant speed deceleration space, see parameters and on Chapter 13.
77