Krups ESPRESSERIA AUTOMATIC EA80 Serie Bedienungsanleitung Seite 23

You can set your appliance to turn off after a pre-programmed number of hours.
The 'CLEAN' light comes on.
Press the - Fig. 32 button as many times as necessary to select the desired duration: 1 = 1h, 2 = 2h, 3 = 3h, 4 = 4h.
To go to the next phase, press the
4. Info (number of cycles)
The light comes on.
To go to the next stage, press the
To leave settings mode, press
!
At any of these stages, you can leave settings mode by pressing the
All of the lights will go off. These settings stay applicable even if there is an electric power cut. You can change these
settings at any time by repeating these operations.
TROUBLESHOOTING, CORRECTIVE ACTIONS
Si l'un des problèmes énoncés dans le tableau persiste, appelez le service consommateur KR
PROBLEM MALFUNCTION
Your appliance detects a fault.
The appliance does not turn on
when the button is pressed.
The coffee grinder makes a strange
noise.
The steam nozzle makes a noise.
The steam nozzle on your appliance
seems partially or completely
clogged.
The steam nozzle makes little or no
milk froth.
No steam comes out of the nozzle.
The auto-cappuccino set makes little
or no froth.
The auto-cappuccino set does not
take in milk.
There is water underneath the
appliance.
After emptying the coffee grounds
collector and cleaning the coffee
drawer (1) , the warning message is still
displayed.
button, or to leave the settings mode, press
button. You will go back to adjustment 1.
.
CORRECTIVE ACTION
Switch off and disconnect the appliance, remove the filter cartridge, wait for a
minute and restart the appliance.
Check your fuses and plug sockets.
Check that the two power plugs are correctly pushed in the socket.
There is a foreign body in the grinder. Disconnect the appliance before
investigating. See if you can extract the foreign body using your vacuum cleaner.
Check that the steam nozzle is correctly attached to its corresponding end
piece.
Ensure that the opening in the end piece is not obstructed by milk residue or
limescale. Unclog the holes with the needle supplied with your appliance.
For milk-based drinks, use very fresh, very cold pasteurised or UHT milk. It is
also advisable to use a cold container. If the results do not improve, try changing
the brand of milk.
Empty the tank and temporarily remove the filter cartridge. Fill the water tank
with mineral water which is high in calcium (> 100 mg/l) and run successive
steam cycles.
Check that the accessory is correctly attached to the appliance, remove it then
replace it.
Check that the flexible tube is not obstructed or pierced and that it is correctly
attached to the accessory so as to make it airtight. Rinse and clean the
accessory (refer to the "Auto-cappuccino accessory" chapter).
Before removing the water tank, wait for 15 seconds after the coffee has finished
flowing so that the appliance finishes its cycle properly.
Check that the drip tray is correctly positioned on the appliance; it should always
be in place, even when the appliance is not in use.
Check that the drip tray is not full.
The drip tray should not be removed during a cycle.
Clean the tank and its connection regularly to avoid the build up of scale, which
can cause leaks.
Remove the coffee drawer
sits. Ensure the coffee drawer
installed. Wait at least 6 seconds before replacing them.
.
button if you have finished your adjustments.
,and wipe clean the area where the coffee drawer
(1)
and the coffee grounds collector are correctly
(1)
(1)
21