Water Treatment - Teuco P013A Serie Gebrauchsanweisung

EN
9 - SET the pump switch to "MAN" (manual) .
Water will begin flowing from the pool through the filter.
10 - bLEEDING ThE FILTER
Turn the bleed valve located on the the filter cap .
Take care over this step, as an accumulation of air in
the filter can cause the system to malfunction
seriously and shorten the life of the pump.
Repeat the operation several times if necessary.
After bleeding the filter, set the pump switch to the
"AUTO" position .

wATER TREATMENT

Treat the water using the products supplied by Teuco, as described in the accompanying manual .
Other equivalent proprietary products can also be used .
The pH value and Chlorine level must be tested chemically at frequent intervals to guarantee the
quality of the water is properly maintained and ensure correct operation of the system .
26